Analog Delay line in multisim

Reply to Thread

Discussion in 'General Electronics Chat' started by Peter001, Apr 13, 2017.

Reply to Thread
  1. Apr 13, 2017 #1
    Peter001

    Thread Starter New Member

    Apr 13, 2017
    1
    0
    I'm trying to construct an analog delay (series of low pass filters) and demonstrate the properties of a transmission line (reflection, attenuating etc.) using a multisim simulation (my attempt attached below). But on the oscilloscope I don't get any kind of reflection. What should I do?

    [​IMG]
     
    #1 Reply
Loading...
Related Forum Posts:
  1. xxxyyyba

    Digital to Analog conversion in Multisim

    Posted by xxxyyyba in forum: General Electronics Chat
    Replies:
    1
    Views:
    2,117
  2. jean_jean

    Programable analog delay line

    Posted by jean_jean in forum: General Electronics Chat
    Replies:
    15
    Views:
    1,355
  3. voice

    How to create delay in Multisim 7?

    Posted by voice in forum: Homework Help
    Replies:
    3
    Views:
    3,892
  4. ziplague

    Signal Delay Analysis of 3Bit Parallel Full-Adder in Multisim

    Posted by ziplague in forum: The Projects Forum
    Replies:
    0
    Views:
    3,282
  5. BAJA

    Multisim, Digital - Analog ground in one schematics

    Posted by BAJA in forum: Electronics Resources
    Replies:
    2
    Views:
    3,233
You May Also Like:

  1. Silicon Labs Bets on the IoT with Thunderboard Reveal and Micrium RTOS Acquisition

  2. The Gentleman Maker's Auto-Apologizer: A Clever, Polite Device for the Everyday Brit

  3. How to Use I/Q Signals to Design a Robust FSK Decoder


Load More Articles