All About Circuits

Altium Copper Pad is not showing in the 3D View

Search Forums New Posts
C

Thread Starter

ChipCircuit

Joined May 1, 2023
73
Hi ,
currently I am designing a circuit with Altium, In the PCB layout, 3D view one IC's copper pads are not showing, If I am taking the footprint view of the component it is there.
1686589317999.png
1686589389083.png
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
H Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) Software & IDEs 0
Y creating COPPER COIN from imported track in Altium PCB Layout , EDA & Simulations 0
S Collision errors on Altium when connecting component thermal pad to bottom layer copper planes PCB Layout , EDA & Simulations 0
Similar threads
Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
creating COPPER COIN from imported track in Altium
Collision errors on Altium when connecting component thermal pad to bottom layer copper planes

You May Also Like

Top