All About Circuits

ADXL330 output signal in Simulink

Search Forums New Posts
L

Thread Starter

legolasx

Joined Aug 5, 2010
1
Hi i'm having a problem in logging signal for an analog accelerometer,ADXL330. i obtained a sinusoidal signal from the simulink environment, which is not the desired output signal (voltage) i wanted, yet the voltage i measured at the physical terminal has a constant output (desired). any1 can help me in this, i'm using a Advantech DAQ card.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
C How Should a Pull-Up Resistor Be Selected for an Open-Drain Output? General Electronics Chat 4
iLEEZi Input,output impedance and impedance matching for audio amp. Homework Help 60
A EL817S Optocoupler Output: Multiple HIGH/LOW Transitions and Recommended Hardware Debouncing General Electronics Chat 9
M I want to protect my Truck's BCM from possible damage, when energizing/de-energizing a coil with one of it's outputs General Electronics Chat 29
hrs Modifying buck/boost module to different output voltage Power Electronics 6
Similar threads
How Should a Pull-Up Resistor Be Selected for an Open-Drain Output?
Input,output impedance and impedance matching for audio amp.
EL817S Optocoupler Output: Multiple HIGH/LOW Transitions and Recommended Hardware Debouncing
I want to protect my Truck's BCM from possible damage, when energizing/de-energizing a coil with one of it's outputs
Modifying buck/boost module to different output voltage

You May Also Like

Top