All About Circuits

5V tolerant pins on STM32F4 chips

G

Thread Starter

Gibson486

Joined Jul 20, 2012
355
I have several 5V signals (pulled up with a 10K) going to a 5V to 3.3V level shifter (LVC series chips). Since several of the IO are 5V tolerant, I could get rid of the LVC series chip. Is there any advisable reason to keep the LVC chip (maybe it is more robust...)? Or is the LVC chip fully redundant?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Fred573 Sharing ADC and GPIO PADs that supports 5V tolerant Analog & Mixed-Signal Design 0
danadak Fault tolerant HW and SW systems Microcontrollers 12
Ehsan Habib 5 VOLT TOLERANT i/o SERIAL COMMUNICATION Microcontrollers 3
Xavier Pacheco Paulino STM32 Nucleo GPIOs, 5V Tolerant? Microcontrollers 1
C Is 5V tolerant the interface (rx, tx) of this module SIM900? General Electronics Chat 1
Similar threads
Sharing ADC and GPIO PADs that supports 5V tolerant
Fault tolerant HW and SW systems
5 VOLT TOLERANT i/o SERIAL COMMUNICATION
STM32 Nucleo GPIOs, 5V Tolerant?
Is 5V tolerant the interface (rx, tx) of this module SIM900?

You May Also Like

Top