Hi all,
I have a design where I'm putting a 32.768KHz crystal and the two 12pF caps about 1.2 inches away from the microcontroller. I don't have much space on the PCB board and I want to avoid putting the crystal on top of the circuit antenna coil that you see in the right upper corner of the picture below. Is this a good design practice to place the crystal on the board the way I'm doing it? Is this going to cause any trouble or noise in the design? Any suggestion?
Thank you,
Robert
I have a design where I'm putting a 32.768KHz crystal and the two 12pF caps about 1.2 inches away from the microcontroller. I don't have much space on the PCB board and I want to avoid putting the crystal on top of the circuit antenna coil that you see in the right upper corner of the picture below. Is this a good design practice to place the crystal on the board the way I'm doing it? Is this going to cause any trouble or noise in the design? Any suggestion?
Thank you,
Robert