Hi all
I have a device that outputs 24V, and I want to lower that voltage to 5V as well as actuate a 12v solenoid on full voltage.
This is the original schematic and it works fine. I have built this circuit and have it connected and proved its usability
Now I need to add the capability to actuate a solenoid only when the input voltage is @ 24v and close when lower than 24v
I have tried to create something here but i feel i'm missing a big part
J1 = Bias power input (24v input)
J2 = Fan control input (24v (PWM?))
J3 = Fan output
J4 = 12v solenoid 250mA (Open @ =12v / Close @ >12v)
J5 = 0v-5v laser output
JP1 = SPDT Switch
+5v = Connected together
+12v = Connected together
Gnd_1 = Connected together
Gnd_2 = Connected together
Can someone tell me what i've done wrong. If this circuit will work? If its flawed entirely?
I have a device that outputs 24V, and I want to lower that voltage to 5V as well as actuate a 12v solenoid on full voltage.
This is the original schematic and it works fine. I have built this circuit and have it connected and proved its usability
Now I need to add the capability to actuate a solenoid only when the input voltage is @ 24v and close when lower than 24v
I have tried to create something here but i feel i'm missing a big part
J1 = Bias power input (24v input)
J2 = Fan control input (24v (PWM?))
J3 = Fan output
J4 = 12v solenoid 250mA (Open @ =12v / Close @ >12v)
J5 = 0v-5v laser output
JP1 = SPDT Switch
+5v = Connected together
+12v = Connected together
Gnd_1 = Connected together
Gnd_2 = Connected together
Can someone tell me what i've done wrong. If this circuit will work? If its flawed entirely?