electronics desing

Hello everyone, I'm currently working on a Hybrid vehicle project called REEV (Range Extended Electric Vehicle) for a competition organized by SAE India. The VCU in our car is connected to critical components like the battery, motor, generator, and various sensors. I need to acquire data such...

I want to design electronics products in modular for data acquisition devices, but I need some suggestions witch one better design and pro cons between using sandwich modular like in Arduino and their shield or using flex cable like in laptop or any similar device?

Hello, I have a question, please guide me and make me correct regarding MOSFET model selection? Although I used ‘nmos4’ both for 3.3V and 5V Vdd (supply voltage) in my simulation(cadence Virtuoso 6.1.6-64b), in both cases, it works fine and gives same results (according to my observation). So...

Hello I am demodulating a signal. In which Low Pass Filter (LPF) is used to attenuate high frequency modulated signal. The input and outup of LPF is shown. The problem is the edges of LPF output signal is not square [as shown in figure] which result in poorly selection of lower and upper...

Hello Everyone, I need help in to generate feedback for fan regulator to the controller. 1. AC Fan require 1 phase Ac supply (230VAC/50Hz) 2. Controller require DC voltage in range of 0 to 3V3 3. System is able to support all type regulator, there different type's...

Hello, May be it simple question ! but i would need the technical reason Why it happen. Problem: I am designing signal isolation circuit using capacitive coupling technique using Cadence , CMOS 0.35micro-meter technology . For that i modulate the information signal using frequency modulator on...

Hello i am new on the forum and i want to ask my 1st question. I have to find the transfer function v(t)/i(t). First of all i calculate the the differential equations and the result is 2+i(t)=ir+c*dv/dt 2+i(t)=e^vr+c*dv/dt Then i have to lenearize the e^v and the result is 2*v+1.38. I think i...

Hello İm tring first circiut. But i need implement this circuit with lm35 (temperature sensor ) . How i can do it ? if i use just potantiometre instead lm35 , can this ciruit can start ?