dc motor

Hi, I'm relatively new to circuit design and I'm trying to create a circuit to turn on/off a 6V DC motor using a microcontroller. To do this, I am using an N-channel MOSFET. The MOSFET appears to be working, because the drain to source resistance when the gate = 0V is ~10 MΩ, and when the gate...

Good day everyone, I am designing a sort of winch system, where the user can pull the package freely, and once they are done, the winch reels back up the string around a drum. I would like to use a DC motor connected to the drum to reel back the string. This means that when the user is pulling...

Background: I'm working with an existing motor+driver board with Vin being supplied by a 4.2V LiPo -> TP4056 Charger Protection Board -> Boost Voltage Regulator. I've also got another subcircuit attached to the end of the TP4056 module through another voltage regulator and diode that powers a...

What's the best way of attaching a wooden (plywood) flywheel to the shaft of a DC motor? The flywheel is relatively small (4 inches in diameter). I'm still deciding on the motor, but the diameter of the motor shaft will probably be somewhere around 5/16 inch. I was thinking of just drilling a...

Hello, My treadmill stopped working (i.e. belt no longer moves) with a loud popping sound. When I inspected the motor-controller board I found a damaged 22 ohms resistor that I replaced. Then, I decided to see if the board works fine, so I put the board back and I used my DMM to measure the...

Hello! I am trying to design a car shade (the thing you put up in your windshield to block the sun) that is automatic with the press of a button. I have an idea of how it will work and the design, but I am struggling with the circuit. Here is some background: The automatic shade will be rolled...

Hello, I am in a research team and is designing a circuit system for powering a motor with battery and supercapacitor. The battery and supercapacitor powers the motor separately and the motor gives regeneration power back to the supercapacitor (motor driver allows for regen). Can experts in this...

Hi, I'm trying to to find a dc drive that will power a higher horsepower treadmill motor ~3-4hp. All the drives I've found will be like 1.5hp @ 90vdc/3hp @ 180vdc. But I don't have a 180vdc motor, the motors I'm looking at are all 130vdc. So I'm not sure what to do about that. Is there a...

Hello İm tring first circiut. But i need implement this circuit with lm35 (temperature sensor ) . How i can do it ? if i use just potantiometre instead lm35 , can this ciruit can start ?