How to use mesh current analysis instead of thevenin's theorem here to solve for all currents and voltages in the following bjt circuit?
How should i make the closed loops in order to analyse?
Hello,
I am studying digital electronics and I am a bit confused about the saturation conditions of the bjt.
I knew that the bjt saturates when the Vce is close to 0 and Vbe >= 0.7. However, when I was reading about TTL I got confused.
Can someone give me some intuition and explain me why in the...
Hi guys, I designed a simple circuit here to use an Arduino Pro mini controlling a heater rod for my personal project. My heater rod is rated at 24V, 25W. I'm controlling the heater rod using a BJT transistor, FMMT617TA which is some leftover parts from my previous project.
After I got my...
I want to study about "finding Input & Output Impedances of Common Emitter BJT Amplifier"
However, I could not find a decent source & document about it.
Could someone supply me with some documents for that.
Then that would be gorgeous for my study.
Thanks :)
Hi, I just have solved one of the bjt common emitter question below.
However, I'm curious that how can I additionally find those things below:
1) Input and Output Impedance
2) AC Gain
Here is the example and my hand draw solution. However, the question only asked to find Vout/Vin...
Also, my...
Hi, I want to study about BJT Common Emitter Large (or bias) and Small Amplifier Circuits.
My question is I could not find a decent sufficient resource neither from youtube nor from google. :(
I want to study about those common emitter large & small signal models, analysis, ac gain, input &...
BJT practice in breadboard
Bipolar transistors have three(3) poles, like The 2N3904 NPN
Middle pole is base?
The left/right poles are chosen arbitrarily,...? If No, how choose the collector?
Ground (-) what should be, and what (+)...?
Hi. The schematic of amplifier using BJT and the result is attached.
What I learned is that the beta, ratio of Ic/Ib, would be constant.
However, the ratio of Ic/Ib varies by the time.
I googled for this and found out that the beta varies with temperature and Ic but does it vary that much...
I know Cmeu is parasitic capacitance in active mode. It's the B-C junction capacitance. But does it change when the npn is operating in saturation mode?
Also in general(not just in saturation mode) what happens to Cmeu at increasing Vce? Does it increase? What other things happen to the...
Greetings everyone,
I am planning to design a current amplifier using an NPN BJT Transistor with an Emitter Follower configuration. On top of that, instead of using batteries, I am using 2 separate LDO voltage outputs as the input voltage(Vin/Vbb) to the BJT as well as the supply voltage...