actuator

Hi there, I want to preface this by saying I am totally new to wiring up electronics and could really use a pointer. I am trying to wire up a exhaust flap actuator Kuster 3 pin) to a wireless control board (DieseRC 433Mhz Universal Wireless Remote Control Switch DC 12V). The thing I am not...

Hello, I am trying to run linear actuator with BTS7960 motor driver and Arduino UNO. But, the code seems fine, wiring seems fine but after uploading the code, the linear actuator does not start. I am using two push buttons to extend and retract the actuator. The code is shown below: byte...

Let me create a scenario to better illustrate the problem I have 1500 pens that I want to individually actuate upwards with 3 different distances, ex: 10mm/15mm/20mm I thought I could use solenoids to do this, but I'm not sure if this is the best option and how accurate the solenoid will be...

Hello. I’m looking for two step pushbutton switches (ON)-(ON). I was looking at this datasheet: https://eu.mouser.com/datasheet/2/603/p4-catalog-pdf-1145024.pdf In the section ”ACTUATORS FOR BASIC SWITCHES” for example rugged seal panel switches doesn’t make sense in reference to the ”P4 PART...

Hi everyone, I don't know why but I'm having a tough time decoding CAN Bus data frames, even after looking at many sources showing bit field diagrams of how the data is supposed to be structured. Background on project/goal My main goal is to connect directly to an electronic turbo actuator...