Hello, I ordered this barcode scanner from AliExpress but have no clue at all how to connect it to Arduino. Any ideas? Connector : http://i.imgur.com/0mw4K6t.jpg
Heey, thanks for your reply! I'm just looking for some kind of adapter just to connect it and make it work.This gives you the connections but you will need a lot more information to drive it properly.
Wow, thank you, let me know about the resultsI've just done an adapter for this barcode reader. Brings out power, UART and USB to a 6 pin wire-up connector and uses a Wurth FFC connector. Will be testing it tomorrow when I make it on our LPKF machine. Will let you know if it works.
I'm intersted about the schematicOK. It's done and it works on USB. It needs the enable pin pulling low to read. Not tried it on serial. Can post the (trivial) schematic and layout if anyone interested. BTW, the reader is very good. We have to read an appalling Code 39 VIN barcode on a Nissan, and it beats a phone hands-down. We also use expensive laser scanners and this is as good. Chazza
I've uploaded the schematic. It makes a single sided board with no linksI'm interested about the schematic
Hi chazzab,I've uploaded the schematic. It makes a single sided board with no links
Thanks AlbertHall,I have attached the manual for E1007 and E1005 scanners. The text below seems to be saying that it will only work for one type of interface - whichever it was supplied as:
Product standard interfaces are: RS232 (DB9 orifice), USB and Keyboard. Standard
interface of different products are not the same, please confirm before purchase
by Duane Benson
by Duane Benson
by Aaron Carman