I want to put a sine wave 1 Vp-p (1kHz) to my op-amp but I don't know what is Vamp and Voff?
what should I put for these 2 values?

 

hi asdf,
Deleted, incorrect information.!
E

 

Vamp is the RMS amplitude of the sine wave signal

I don't know Pspice, but in LTspice the amplitude value is the peak voltage.

 

hi alec,
You are of course correct, I must stop eating Christmas Sherry laced mince pies.[ what was I thinking]
Eric

 

So, for 1Vpp, set Vampl = 0.5. For no DC offset, set Voff = 0.

Hi Eric. Thanks for reminding me to top up my mince pie supply .

 

Take the simplest circuit, consisting of such a source and a resistor. Set arbitrary values and see what happens. In general, it is necessary to read the descriptions used programs.

 

Thanks a lot