Facebook
Google
GitHub
Linkedin
Here the Panel is loaded with a 12 Ohm resistor. I let LTSpice compute the output voltage. Obviously, the current out of the Panel and into the resistor would be 14.37/12 = 1.197A
Wasted power from Solar Panel by Reg
- Thread starter parmaja
- Start date
Resistor has a straight I-V curve starting from 0 - from Ohm's law V = I*R.
If you draw this straight line, it'll cross the Mike's green line somewhere. The crossing point determines the voltage and current you get with the resistor. If you find a good resistor it may go right through the MPPT.
Lestraveled
- Joined May 19, 2014
- 1,946
Well done Mike
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| F | Could This Primary-Side RC/D Snubber Failure Cause Repeated Power Transistor Breakdown? | Technical Repair | 0 | |
| J | 110V AC/DC TO 13.5 V DC | Power Electronics | 10 | |
|
wasted water | Off-Topic | 56 | |
|
Designing A new Wasted Power Recovery system on gasoline vehicles | Power Electronics | 28 | |
| M | Wasted power | Power Electronics | 1 |
