Thank you very much, can you please tell me what kind of sensor did you use?Here is the version I used,.
It uses a bridge before the motor to drive it with DC.
I went down to very low rpm for a band saw.
Max.
Thank you very much, can you please tell me what kind of sensor did you use?Here is the version I used,.
It uses a bridge before the motor to drive it with DC.
I went down to very low rpm for a band saw.
Max.
Ok but how I should connect it to PIN 12?It shouldn't be hard to set up a slot opto type.
Did you mean like in the attachment?Most appear to use just contact closure from pin8 & pin12.
with a ~3k series resistor, it looks like it may be tricky to integrate an opto given the input pin Vmax.
by Don Wilcher
by Aaron Carman
by Duane Benson
by Jake Hertz