Hey guys,
i am new to the whole pcb desing scene. So im sure you can help me with my beginner questions
The circuit works okish:
- It delivers 5V
- It cuts the voltage by a short circuit
- It charges the LiPo
BUT, and thats a big but.
- It only can sustain ~100mA current, everthing above will trigger the over current detection and it wil shut down.
- It only loads with 500mA, and it does not load from USB-C to USB-C Cable only with a USB-A to USB-C cable.
Which makes it useless.... It should deliver 2,4A and charge with 1,7A. I can not see what i did wrong, maybe your eyes can see it more clear than mine.
Here is the charging IC IP5306-LC datasheet:
IP5306
If you can tell me where to find these in english, i would also appreaciate this a lot
This is my diagram:
best regards!
i am new to the whole pcb desing scene. So im sure you can help me with my beginner questions
The circuit works okish:
- It delivers 5V
- It cuts the voltage by a short circuit
- It charges the LiPo
BUT, and thats a big but.
- It only can sustain ~100mA current, everthing above will trigger the over current detection and it wil shut down.
- It only loads with 500mA, and it does not load from USB-C to USB-C Cable only with a USB-A to USB-C cable.
Which makes it useless.... It should deliver 2,4A and charge with 1,7A. I can not see what i did wrong, maybe your eyes can see it more clear than mine.
Here is the charging IC IP5306-LC datasheet:
IP5306
If you can tell me where to find these in english, i would also appreaciate this a lot
This is my diagram:
best regards!