@Dodgydave Thanks. Found that data sheet with help from @MisterBill2
@shortbus the "Sink" is connected to the Gate. The pull up resistor should pull the signal high when the dimmer is at (for example) 50%. However, when the dimmer is turned either full high or full low, in one of those configurations the iggy should work. For some reason it's not. That's what I'm looking into on the data sheet right now. I don't understand why it's not switching on.
I've tested the iggy. It works fine without the dimmer in circuit. I can touch B+ to the gate and it switches on the test lamp. (the test lamp is only there to verify circuit functionality) (it should dim)
@shortbus the "Sink" is connected to the Gate. The pull up resistor should pull the signal high when the dimmer is at (for example) 50%. However, when the dimmer is turned either full high or full low, in one of those configurations the iggy should work. For some reason it's not. That's what I'm looking into on the data sheet right now. I don't understand why it's not switching on.
I've tested the iggy. It works fine without the dimmer in circuit. I can touch B+ to the gate and it switches on the test lamp. (the test lamp is only there to verify circuit functionality) (it should dim)
Last edited: