Hello...
I'm analysing a Tri-Phase Full-Bridge Thyristor based rectifier in Matlab Simulink. I have searched for the circuit schematic and assembled it.
Now I'm being asked to plot a couple of values based on an image from a book we are following in classes that is Ned Mohan's book.
Teacher is asking us to plot:
\(v_{An}\)
\(i_{A}\)
\(i_{DA+}\)
\(i_{D}\)
following picture 8.24 from Ned Mohan's books which is the following
The circuit I'm simulating in Matlab Simulink is the following:
My question is if the spot in the circuit where I have Scope V_An is the correct spot for the asked VAn voltage? And for 'id' current? Would it be the current out of Vdc?
I'm analysing a Tri-Phase Full-Bridge Thyristor based rectifier in Matlab Simulink. I have searched for the circuit schematic and assembled it.
Now I'm being asked to plot a couple of values based on an image from a book we are following in classes that is Ned Mohan's book.
Teacher is asking us to plot:
\(v_{An}\)
\(i_{A}\)
\(i_{DA+}\)
\(i_{D}\)
following picture 8.24 from Ned Mohan's books which is the following
The circuit I'm simulating in Matlab Simulink is the following:
My question is if the spot in the circuit where I have Scope V_An is the correct spot for the asked VAn voltage? And for 'id' current? Would it be the current out of Vdc?
