You guys helped me a great deal before…. So ill try again. Asking for help politely
i do have an installation that features around 16 fault signals. Meaning, if any of my 16 units have an error
the according channel switches 24v. Now im looking for a way to translate these digital signals to a voltage that indicates to me which unit is faulty. I have a gsm that allows me to check a 0-60v input on the go. So my idea was to find a way to translate the 16 inputs accordingly. Say unit #1 goes down gives 1V, unit #5 goes down gives 5V, unit #12 = 12V and so on. I dont mind if it works for more than 16 channels. But thats not a must.
Any idea how to go about this? My supply voltage is a single 24V line.
Thanks!
i do have an installation that features around 16 fault signals. Meaning, if any of my 16 units have an error
the according channel switches 24v. Now im looking for a way to translate these digital signals to a voltage that indicates to me which unit is faulty. I have a gsm that allows me to check a 0-60v input on the go. So my idea was to find a way to translate the 16 inputs accordingly. Say unit #1 goes down gives 1V, unit #5 goes down gives 5V, unit #12 = 12V and so on. I dont mind if it works for more than 16 channels. But thats not a must.
Any idea how to go about this? My supply voltage is a single 24V line.
Thanks!