Hi all.
I am new to this forum and relatively new to microcontrollers.
I have been developing a system using a TI micro mainly due to the support package from Matlab Simulink as I am experienced in using Simulink for control systems development.
I am wanting to design some hardware that can communicate over 10 separate CAN busses. The system will replicate various vehicle systems and ECU's therefore using the incoming CAN data, perform some calculations and processing and then communicate back to the main ECU via CAN.
The micro I am using currently has the ability for 2 CAN busses only. What is the best wat to achieve 10? Would it be to use a multiple of micros and then have them communicate to each other all the data? If so how do I go about this? Would SPI communication between the micros be sufficient?
Thanks
I am new to this forum and relatively new to microcontrollers.
I have been developing a system using a TI micro mainly due to the support package from Matlab Simulink as I am experienced in using Simulink for control systems development.
I am wanting to design some hardware that can communicate over 10 separate CAN busses. The system will replicate various vehicle systems and ECU's therefore using the incoming CAN data, perform some calculations and processing and then communicate back to the main ECU via CAN.
The micro I am using currently has the ability for 2 CAN busses only. What is the best wat to achieve 10? Would it be to use a multiple of micros and then have them communicate to each other all the data? If so how do I go about this? Would SPI communication between the micros be sufficient?
Thanks