Facebook
Google
GitHub
Linkedin
Hi
I'm playing with a TMC2130 module in standalone mode. I can get the module to drive a motor correctly, but i cannot get the DIAG0 and DIAG1 pin to output when the module is in error.
The data sheet on page 72 states the DIAG0 pin should toggle when the module is held in reset. I cannot get this to happen. I have pulled the pin high with a 100k and DIAG1 low with a 50k resistor.
I would like to monitor these pins so if the motor errors i can reset my project
Thanks
Snow
I'm playing with a TMC2130 module in standalone mode. I can get the module to drive a motor correctly, but i cannot get the DIAG0 and DIAG1 pin to output when the module is in error.
The data sheet on page 72 states the DIAG0 pin should toggle when the module is held in reset. I cannot get this to happen. I have pulled the pin high with a 100k and DIAG1 low with a 50k resistor.
I would like to monitor these pins so if the motor errors i can reset my project
Thanks
Snow
