Hi...as pictured, one of four switches has been dislodged after repetitive use, and taken the PCB contacts with it...
There seems to be two small areas that could accept a soldered wire...
Has any got any suggestions..?
Thanks
Tinkerer

 

Your pictures are not very clear. I cannot see what you are trying to show. Please take clearer pictures and upload them individually; not in a collage.

 

It appears to be a SMD device, If mine, I would prefer a thro-hole device for a switch!

 

Your pictures are not very clear. I cannot see what you are trying to show. Please take clearer pictures and upload them individually; not in a collage.

Sorry its difficult to get a good photo. This is the one showing the PCB area where the missing switch was located