Hi, All,
I use UA741CP to amplify a 0Volts, 2.5volts square wave. The design circuit is shown below. I use RG=RF=1K ohm. VCC=15Volts, VDD is connected to 0V. Pin1 and Pin5 are not connected to anything. The output is supposed to be 5Volts in this case. However, it gives me 1.2 volts instead. Can anymore help me out with this? Thank you in advance.
Here is the datasheet:
https://www.digikey.com/en/products/detail/texas-instruments/UA741CP/382197?utm_adgroup=Integrated Circuits&utm_source=google&utm_medium=cpc&utm_campaign=Dynamic Search_EN_RLSA_Cart&utm_term=&utm_content=Integrated Circuits&gclid=Cj0KCQjwwY-LBhD6ARIsACvT72OyoSaOfkpwHz2pMEJBI6GXvZj_dBEYQs2F5jEmYdMb5n6U5tWMa-gaAqStEALw_wcB
I use UA741CP to amplify a 0Volts, 2.5volts square wave. The design circuit is shown below. I use RG=RF=1K ohm. VCC=15Volts, VDD is connected to 0V. Pin1 and Pin5 are not connected to anything. The output is supposed to be 5Volts in this case. However, it gives me 1.2 volts instead. Can anymore help me out with this? Thank you in advance.
Here is the datasheet:
https://www.digikey.com/en/products/detail/texas-instruments/UA741CP/382197?utm_adgroup=Integrated Circuits&utm_source=google&utm_medium=cpc&utm_campaign=Dynamic Search_EN_RLSA_Cart&utm_term=&utm_content=Integrated Circuits&gclid=Cj0KCQjwwY-LBhD6ARIsACvT72OyoSaOfkpwHz2pMEJBI6GXvZj_dBEYQs2F5jEmYdMb5n6U5tWMa-gaAqStEALw_wcB
Last edited: