I have 220Vac/50Hz application which require a fuse in series in case of overcurrent. Earlier I was using glass fuse. But I have noticed whenever it blows it goes bang. I dont want that it create such bang.
I have seen this video:
& noticed that ceramic fuses dont create such noise when blown. Can I replace glass fuse by these.
Disadvantage I read are:
1. When ceramic fuse blows, there is no physical mark on cermaic to identify that it i blown. Only way is by multimeter. While glass fuse gets black & can be identified by eyes.
2. Cermaic fuses are slower than glass fuse in breaking. Can it affect the circuit?
Any other point, or any other fuse type which dont get blown by such noise.
Input is 220Vac,50Hz, load is around 400mA.
I have seen this video:
Disadvantage I read are:
1. When ceramic fuse blows, there is no physical mark on cermaic to identify that it i blown. Only way is by multimeter. While glass fuse gets black & can be identified by eyes.
2. Cermaic fuses are slower than glass fuse in breaking. Can it affect the circuit?
Any other point, or any other fuse type which dont get blown by such noise.
Input is 220Vac,50Hz, load is around 400mA.