I AM REPAIRING A DAB RADIO ROBERTS RAMBLER BT. I HAVE FOUND USEUL DIAGNOSTIC ADVICE ON ANOTHER THREAD BUT I AM ONE STEP BACK AS I WOULD APPRECIATE INFO ON GETTING THE PCB OUT.
CHRIS

 

Please refrain from using ALL CAPS when posting on forums -- it is considered shouting and many readers will just ignore your post. Using it sparingly to emphasize words or phrases is fine.

 

Welcome to AAC! My hearing is still very good...

I WOULD APPRECIATE INFO ON GETTING THE PCB OUT

Do you have any info on the device or a well-focused picture of the board you're trying to remove?

 

Please refrain from using ALL CAPS when posting on forums -- it is considered shouting and many readers will just ignore your post. Using it sparingly to emphasize words or phrases is fine.

My mistake. I did not notice. No excuse except 76 year old.
Chris

 

I am trying to use the Forum correctly. So I found info on what maybe a different Forum. It was submitted by "shooter1967" and is very useful. It has photos of the PCB. This problem is getting the case apart to get the PCB. Cannot see the method but "shooter1967" has already done it. How do I get to ask him. I did try on the Thread but was told no as it was in 2023 but considered as over one year old.
Please help
Chris

 

That member was only active for that one thread and hasn't been here for well over a year, so you may not have much luck in contacting them. They may or may be have opted to receive e-mail notifications from the site. But let's give it a try.

@shooter1967: The member above, Gorey48, ran across your Roberts Rambler BT Dab radio repair thread and is interested in knowing how you got the case of your radio apart. Can you give them some info. Thanks.

You can also post a note to them in their thread, and they may get that notification (which is a different type). Normally, we discourage "necroposting", but in this case your request is specific to that member and relevant to that thread.