use a rlc circuit to design a band stop filter. At frequency 1Hz and a stop-bandwidth of 2kHz. Use component values and a 5-10% error is commonly acceptable.
Provide the schematic, frequency response of the gain magnitude, and frequency response of phase.
I don't have much experience with "designing" filters.
I have a schematic made, which is just two resistors, one inductor, and one capacitor.
I am not sure how to figure out the component values and part b and c.
Any help to get me started.
Thanks
frequency=1/(2*pi*sqrt(LC))
and i know BW=(frequency)/Q
not sure where to go from there.
Provide the schematic, frequency response of the gain magnitude, and frequency response of phase.
I don't have much experience with "designing" filters.
I have a schematic made, which is just two resistors, one inductor, and one capacitor.
I am not sure how to figure out the component values and part b and c.
Any help to get me started.
Thanks
frequency=1/(2*pi*sqrt(LC))
and i know BW=(frequency)/Q
not sure where to go from there.