Hi,
I'm rewiring a black and Decker radial arm saw R1450, I am not quite understand the switch it used as picture (4) attached. The manual said it is a Overload Protector, that has one wire in, two wires out, and a red button, the thing is the three wires all conduction no matter the button pressed or not, at the picture (3), the top left is the switch. what should I use to replace this Overload Protector?
At the picture (3), the bottom left is a kind of relay, I can't know how it works, may I use a AC relay to replace it?
there are four wires go into the motor, is this mean it is brake build-in motor?
Thanks
Adam
I'm rewiring a black and Decker radial arm saw R1450, I am not quite understand the switch it used as picture (4) attached. The manual said it is a Overload Protector, that has one wire in, two wires out, and a red button, the thing is the three wires all conduction no matter the button pressed or not, at the picture (3), the top left is the switch. what should I use to replace this Overload Protector?
At the picture (3), the bottom left is a kind of relay, I can't know how it works, may I use a AC relay to replace it?
there are four wires go into the motor, is this mean it is brake build-in motor?
Thanks
Adam
Last edited: