I have had good experience with a guy who rewound a toroid for me.
So I am thinking of asking him to rewind my auto TX which has a bad spot where the wiper touches at around 120V.
It's rated at 2 Amps.
I dunno if I need to coat the winding with carbon or not so that the wiper slides smoothly.
Any hints are most welcome.
Primary question is to beef it up.
I am thinking of asking him to use a bit thicker wire so I can increase the current.
I dunno how much or what the limit is.
Any pointers or advice any one ?
So I am thinking of asking him to rewind my auto TX which has a bad spot where the wiper touches at around 120V.
It's rated at 2 Amps.
I dunno if I need to coat the winding with carbon or not so that the wiper slides smoothly.
Any hints are most welcome.
Primary question is to beef it up.
I am thinking of asking him to use a bit thicker wire so I can increase the current.
I dunno how much or what the limit is.
Any pointers or advice any one ?