I try to reuse a Polk soundbar, its amplifier board is damaged. What I am trying to do is to reuse the power key on the soundbar to control the power on/off of the amplifier that I put in to replace the damaged one.
the control panel on the soundbar box is shown above, it uses a 11 pin connector. Below are the pin on the original board. I hope someone could explain how to test the power key on/off. I am not going to use IR, only use the power key.
Thank you very much.
I need some directions to get
the control panel on the soundbar box is shown above, it uses a 11 pin connector. Below are the pin on the original board. I hope someone could explain how to test the power key on/off. I am not going to use IR, only use the power key.
Thank you very much.
I need some directions to get