All About Circuits

Repair welding machine

shortbus

shortbus

Joined Sep 30, 2009
10,045
Look to see if your rectifiers are good. Most times MMA or stick welding is just AC, but MIG is DC so there are rectifiers to covert the AC to DC.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B FIMER X164 ARC small welding machine yellow light failure(yellow light turns on) Technical Repair 0
B EPS GENERA 161 welding machine no output voltage, no 24 V reading on the relay's Technical Repair 1
B KL MMA160 inverter igbt arc welding machine does not weld although it gives an appropriate value of 52 output voltage Technical Repair 0
PhysicsSolvesAll "If all the IGBTs are good, then all the SMD resistors, capacitors and zeners on the legs of the IGBTs are good" Technical Repair 5
PhysicsSolvesAll The outputs of the FIMER 201 welding machine give 0 Volts and a clicking sound is heard from the control circuit Technical Repair 3
Similar threads
FIMER X164 ARC small welding machine yellow light failure(yellow light turns on)
EPS GENERA 161 welding machine no output voltage, no 24 V reading on the relay's
KL MMA160 inverter igbt arc welding machine does not weld although it gives an appropriate value of 52 output voltage
"If all the IGBTs are good, then all the SMD resistors, capacitors and zeners on the legs of the IGBTs are good"
The outputs of the FIMER 201 welding machine give 0 Volts and a clicking sound is heard from the control circuit

You May Also Like

Top