Facebook
Google
GitHub
Linkedin
Hello everyone,
I’m looking for some help regarding the power board of my Intex ZR200. Unfortunately, some components on the board are burnt, and although the board has been sent for repair, it still doesn’t work properly. I suspect that the repair may not have replaced the correct components.
Specifically, I’m looking for a circuit diagram or component layout to verify the components at locations Q1 and R5, as I suspect these might not have been properly replaced. Additionally, when I measure the voltage on the wires supplying the motor, I only get around 10 mV, even though the motor operates on 7.2V DC.
I’ve attached some pictures of the board for reference. Any advice or insights would be greatly appreciated!
Thank you in advance!
I’m looking for some help regarding the power board of my Intex ZR200. Unfortunately, some components on the board are burnt, and although the board has been sent for repair, it still doesn’t work properly. I suspect that the repair may not have replaced the correct components.
Specifically, I’m looking for a circuit diagram or component layout to verify the components at locations Q1 and R5, as I suspect these might not have been properly replaced. Additionally, when I measure the voltage on the wires supplying the motor, I only get around 10 mV, even though the motor operates on 7.2V DC.
I’ve attached some pictures of the board for reference. Any advice or insights would be greatly appreciated!
Thank you in advance!
