Hi, I have a Basement Watchdog Dual Float Switch that turns on but doesn't turn off. I was wondering if there was anything I could replace on the board that would fix the issue. In my quest to fix the issue, it lead me to replacing the relay, but that did not fix it. Thanks in advanced.

 

Hi,
Have you got some information on your float switch, how should/does it operate?
Good luck............

 

Does the switch physically turn On and Off? I have seen plenty of float switches get stuck be it debris in a sump or corrosion. I would start by making sure your board is getting good data from the float switch.

Ron

 

Looks like a NE555 chip, is there one float to sense empty and when full, if so pins 2 and 6 will be the inputs and pin 3 will be the output to switch on the relay, pretty easy to repair.

 

This is the product https://www.basementwatchdog.com/basement-watchdog-dual-float-switch/

 

@wasabad,
Thanks for your reply, we have the same switch on our little pool (30 gallons or * 5 litres).
The small reed relay inside was cracked. A new reed relay fixed it.