Hello all
I am a complete newcomer to electronics.. I am basically looking for advice on the diagram seen in this post
Basically I want to pass a magnet (stuck to a clock hour hand) over a reed switch which then powers a motor at 3v and plays a recorded sound on one of those cheap greeting card circuits
(1) below shows the general setup without the greeting card sound circuit.
- I need to output 3v from the 2 1.5 v D batteries, is this possible?
(2) greeting car circuit
- Is it possible to somehow connect the greeting car circuit to (1) if so how?? It needs to be powered from the 2 D batteries and the current push switch to be removed and operated by the reed switch in (1)
The overall outcome I want is for the reed switch to power the motor for the duration the magnet is over the reed switch and to play the recodered sound in circuit (2) once. (I tested circuit (2) with the reed switch and it plays once then stops, no repeat)
Any help appreciated
Thanks
Dave
I am a complete newcomer to electronics.. I am basically looking for advice on the diagram seen in this post
Basically I want to pass a magnet (stuck to a clock hour hand) over a reed switch which then powers a motor at 3v and plays a recorded sound on one of those cheap greeting card circuits
(1) below shows the general setup without the greeting card sound circuit.
- I need to output 3v from the 2 1.5 v D batteries, is this possible?
(2) greeting car circuit
- Is it possible to somehow connect the greeting car circuit to (1) if so how?? It needs to be powered from the 2 D batteries and the current push switch to be removed and operated by the reed switch in (1)
The overall outcome I want is for the reed switch to power the motor for the duration the magnet is over the reed switch and to play the recodered sound in circuit (2) once. (I tested circuit (2) with the reed switch and it plays once then stops, no repeat)
Any help appreciated
Thanks
Dave