All About Circuits

PROFINET and ETHERNET, and what is VNC?

Ya’akov

Ya’akov

Joined Jan 27, 2019
9,148
eetech00 said:
Which post?
Click to expand...
abu1985 said:
Would I still need a crossover cable to use the sniffer?
Click to expand...
You will need whatever the proper cable is to make the link. If you get a link light (or traffic showing on the sniffer), the cabling is good.

At this point it would be very unlikely a laptop ethernet port would not be Auto MDI-X, but in any case, if you get a link indication (light or "network connected"), or the sniffer sees traffic, cabling is not the issue.
 
E

eetech00

Joined Jun 8, 2013
3,946
Yaakov said:
You will need whatever the proper cable is to make the link. If you get a link light (or traffic showing on the sniffer), the cabling is good.

At this point it would be very unlikely a laptop ethernet port would not be Auto MDI-X, but in any case, if you get a link indication (light or "network connected"), or the sniffer sees traffic, cabling is not the issue.
Click to expand...
Hmmm...not quite what I said....but ok..

eT
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
G Establish an ethernet communication on a system ... Microcontrollers 2
I Solderable SBC with ethernet and integrated storage. Microcontrollers 2
maitrey Communication Protocols :- DeviceNET, Profibus-DP and Profinet Automation, Robotics & Control 10
E Using a PROFIBUS slave HMI in a PROFINET system Automation, Robotics & Control 0
A CX Programmer and Profinet configuration Automation, Robotics & Control 2
Similar threads
Establish an ethernet communication on a system ...
Solderable SBC with ethernet and integrated storage.
Communication Protocols :- DeviceNET, Profibus-DP and Profinet
Using a PROFIBUS slave HMI in a PROFINET system
CX Programmer and Profinet configuration

You May Also Like

Top