Hello everyone,
I ran into a problem when I was trying to run a 9V DC motor. I designed a simple n-channel E-MOSFET circuit that can run a motor and control its speed, however, the motor did not work. My circuit is working on breadboard and there's no issue regarding wiring; I replaced the motor with an LED to test it and it worked. So it is just the motor. Any idea as to why is it not working?
I attached my simulation below, I couldn't find a motor symbol in Multisim so I replaced it with an inductor.
I ran into a problem when I was trying to run a 9V DC motor. I designed a simple n-channel E-MOSFET circuit that can run a motor and control its speed, however, the motor did not work. My circuit is working on breadboard and there's no issue regarding wiring; I replaced the motor with an LED to test it and it worked. So it is just the motor. Any idea as to why is it not working?
I attached my simulation below, I couldn't find a motor symbol in Multisim so I replaced it with an inductor.
Attachments
-
10.9 KB Views: 13