I am doing on one project involving communication between I/O sensors.
now we start to write code for the sensors communication.
and in order to test the code, I would like to use the PC parallel port to give command to the sensor.
but I donot know how to design the interface between the PC parallel port and the sensor parallel port. is there any convenient way to realize the talk?

thanks very much if any comments raised.
attached the documents for the sensor used.

 

Hello,

Here I found a page on programming and interfacing the parallel port.
http://electrosofts.com/parallel/index.html

I hope this is of some help.

Greetings,
Bertus