All About Circuits

power limitations for m79hx mixer

Search Forums New Posts
Y

Thread Starter

yef smith

Joined Aug 2, 2020
1,459
Hello ,there is a component as shown below,in which it could be used as phased detector as shown in the data sheet below.
based on the data sheet , i put my inputs at LO and RF inputs and IF is my phase detector (DC) output.
on one hand they say that maximal input power is 21dBm
on the other table they say that we have an IP3 compression at 0dB.
I am confused.
What is the proper input power for this mixer used as a phased detector?

https://cdn.macom.com/datasheets/M79H_M79HC.pdf
1689534448361.png

1689534472389.png
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
thinkboodles How do I power my circuit? and add Voltage sources in mV ? PCB Layout , EDA & Simulations 8
E Working on an RFPD (Radio Frequency Power Detector)D, but I have zero experience designing a circuit board. Analog & Mixed-Signal Design 19
T which components are most vulnerable to ESD?? (switch mode power supply ics?) General Electronics Chat 9
C tracing power to pins on a Marklift board Technical Repair 0
Y calculating near end power sum cross talk from S-param file Wireless & RF Design 0
Similar threads
How do I power my circuit? and add Voltage sources in mV ?
Working on an RFPD (Radio Frequency Power Detector)D, but I have zero experience designing a circuit board.
which components are most vulnerable to ESD?? (switch mode power supply ics?)
tracing power to pins on a Marklift board
calculating near end power sum cross talk from S-param file

You May Also Like

Top