PIC18f- "Target Device ID (0x0) does not match expected Device ID"
hi everyone,
im new here but i read a similar topic about programming and erasing with pickit3 and a flash pic18f and was hoping some one could help me get these pic18f to read and program again.
i got a few development boards with pic18f flash micro controllers on them. they work fine but I want to use them for something else.
when i try to read or erase them with the pickit3 and MPLAB IPE it keeps telling me "Target Device ID (0x0) does not match expected Device ID"
I even took them off and put them in a socket to dip to isolate any problems.
I tried all voltages from 4v-5v in MPLAB IPE and tried erasing at all voltages even tried LVP. I tried to fill in the entire memory and erase again but all attempts to program fail.
I not sure where the BULK ERASE function is but im pretty sure the erase button i used is sufficent.
Does any one know how I can erase or reset this microchip pic18f chips so I can program them?
hi everyone,
im new here but i read a similar topic about programming and erasing with pickit3 and a flash pic18f and was hoping some one could help me get these pic18f to read and program again.
i got a few development boards with pic18f flash micro controllers on them. they work fine but I want to use them for something else.
when i try to read or erase them with the pickit3 and MPLAB IPE it keeps telling me "Target Device ID (0x0) does not match expected Device ID"
I even took them off and put them in a socket to dip to isolate any problems.
I tried all voltages from 4v-5v in MPLAB IPE and tried erasing at all voltages even tried LVP. I tried to fill in the entire memory and erase again but all attempts to program fail.
I not sure where the BULK ERASE function is but im pretty sure the erase button i used is sufficent.
Does any one know how I can erase or reset this microchip pic18f chips so I can program them?