If a circuit uses a multi channel opt photo transistor type isolator, what is the isolation rating between channels on the output side.
Looking at stand DIP type packages with 2.54mm pin spacing (and pins about 1.2mm wide), I'm guessing that the gap of 1.3mm between pins provides much less than the rated isolation voltage of the device.
Would potting the output side in epoxy help to raise the rating (preventing flashover etc) ?
Looking at stand DIP type packages with 2.54mm pin spacing (and pins about 1.2mm wide), I'm guessing that the gap of 1.3mm between pins provides much less than the rated isolation voltage of the device.
Would potting the output side in epoxy help to raise the rating (preventing flashover etc) ?