I'm using the Analog.com site, that's Linear Technology, I guess. On the search page, and I'm getting confused by the range fields, and the titles. So for example with an op-amp http://www.ti.com/lit/ds/symlink/rc4580.pdf
https://www.analog.com/en/parametricsearch/11070#/
Page 5 Input bias current typ. 5nA Max 500nA. Then putting that into the site, for the Ibias boxes , is the left field the typical value, or min, or ???
For an op-amp that says Vcc is +/-18V, Vcc +2-16V Vee –2–16V, how should that be put into their fields for Vspan min and Vspan max ? the pop-up info says max/min Supply Voltage Vs+ to Vs-, but then the have the boxes as a lower to upper range, or ..??? Or just fill in Max +18 on the right, min +2 on the right ?
Never mind that op-amp or which 1 I want, doesn't matter, I'm just wondering about the normal way these sites normally are, thanks
I don't like trying to find parts in LTSPice, hope it gets easier
https://www.analog.com/en/parametricsearch/11070#/
Page 5 Input bias current typ. 5nA Max 500nA. Then putting that into the site, for the Ibias boxes , is the left field the typical value, or min, or ???
For an op-amp that says Vcc is +/-18V, Vcc +2-16V Vee –2–16V, how should that be put into their fields for Vspan min and Vspan max ? the pop-up info says max/min Supply Voltage Vs+ to Vs-, but then the have the boxes as a lower to upper range, or ..??? Or just fill in Max +18 on the right, min +2 on the right ?
Never mind that op-amp or which 1 I want, doesn't matter, I'm just wondering about the normal way these sites normally are, thanks
I don't like trying to find parts in LTSPice, hope it gets easier
Last edited: