Hi guys.
I've recently come across an old printer power supply and i'm wondering if i could use it to power a small stepper motor I have??. The only thing I'm unsure of is its 3 wire output. See picture below.
On the transformer it states, the left wire is 32Volts @ 375mA, the right wire is 16Volts @ 500mA and the centre wire is Ground.
I've already tried to connect the 32 volt wire and ground to my driver but it doesn't work.
Anyone have any ideas??.
I've recently come across an old printer power supply and i'm wondering if i could use it to power a small stepper motor I have??. The only thing I'm unsure of is its 3 wire output. See picture below.
On the transformer it states, the left wire is 32Volts @ 375mA, the right wire is 16Volts @ 500mA and the centre wire is Ground.
I've already tried to connect the 32 volt wire and ground to my driver but it doesn't work.
Anyone have any ideas??.
Attachments
-
288.9 KB Views: 33