All About Circuits

Net has fewer than two connections in orcad

K

Thread Starter

kapiliitd

Joined Nov 30, 2015
1
Hi All
I am working in schematic design in Orcad. When I Checked the DRC rule it is showing the error.
net has fewer than two connections in VCC and ground.

Can somebody tell me how to solve this problem?

Thanks in advance.
 
crutschow

crutschow

Joined Mar 14, 2008
24,749
There is a problem with the connections in the circuit to VCC and ground.
Do you have connections to both those points in your schematic?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Analog Ground How were "Outside Foil" connections on vintage foil capacitors documented? General Electronics Chat 16
spinnaker Light Rebuild: Lots of small LEDs or fewer larger LEDs? General Electronics Chat 22
A Many 1 Bit DRAM to Fewer 4 Bit? General Electronics Chat 16
P WARNING DRC0007: Net has no driving source test[0..1]: WARNING DRC0006: Net has fewer General Electronics Chat 3
S Exporting fewer data points in ngspice General Electronics Chat 0
Similar threads
How were "Outside Foil" connections on vintage foil capacitors documented?
Light Rebuild: Lots of small LEDs or fewer larger LEDs?
Many 1 Bit DRAM to Fewer 4 Bit?
WARNING DRC0007: Net has no driving source test[0..1]: WARNING DRC0006: Net has fewer
Exporting fewer data points in ngspice

You May Also Like

Top