So basically I have a problem. I need to wire spinning motor, a battery, and another motor to the circuit board, but I don't know how and where. Can someone be so nice and help me? The electonics that need to be wired are in the picture.

 

Given the quality of the photo, and the lack of other information, the best I can do is make a guess but it seems that,,,

The battery pack goes here:



Red on VCC and Black on G

The two motors red or postive leads go on these:



and



With the black or negatives on here:



But I have no way to know which motor is 1 and which 2.

The wires are supposed to come from the component side, through the holes.

DISCLAIMER: I think I am right, proceed at your own risk.

 

Given the quality of the photo, and the lack of other information, the best I can do is make a guess but it seems that,,,

The battery pack goes here:

View attachment 172442

Red on VCC and Black on G

The two motors red or postive leads go on these:

View attachment 172443

and

View attachment 172444

With the black or negatives on here:

View attachment 172445

But I have no way to know which motor is 1 and which 2.

The wires are supposed to come from the component side, through the holes.

DISCLAIMER: I think I am right, proceed at your own risk.

Thank You so much. I will try doing it later and reply if it works