Hello guys,
I have a 95W Xitanium LED driver with the ability to adjust the Amp output. I am planning on using x15 Cree XP-G3 LED's with forward voltage @ 2000 mA/ 3.06V (believe the calculations came to 6.12 W per led). The issue that I am attempting to grasp is the LED driver is set at 2750 mA default with no resistor on the RSET.
How/ what resistor do I wire onto the Rset? I attached the driver and led spec sheets and the driver sheet dose have the ohms chart for the Rset to mA values. I have googled this issue and looked through forums but it appears that people have usually used fixed output LED drivers. I appreciate the help, thanks.
I have a 95W Xitanium LED driver with the ability to adjust the Amp output. I am planning on using x15 Cree XP-G3 LED's with forward voltage @ 2000 mA/ 3.06V (believe the calculations came to 6.12 W per led). The issue that I am attempting to grasp is the LED driver is set at 2750 mA default with no resistor on the RSET.
How/ what resistor do I wire onto the Rset? I attached the driver and led spec sheets and the driver sheet dose have the ohms chart for the Rset to mA values. I have googled this issue and looked through forums but it appears that people have usually used fixed output LED drivers. I appreciate the help, thanks.
Attachments
-
2.3 MB Views: 2
-
1.2 MB Views: 6