I’m a student and I would love your help. I’d like to make the bellow schematics into an analog circuits and PCB. It should ideally sweep between 300 Mhz to 1000 Mhz with multiple antennas . I would also appreciate suggestions from you on how to improve this circuit. Thanks

 

Do you have a schematic capture PGM?
There is free Kicad, (bit of a learning curve),
This will enable you to make the files (Gerber) necessary for a board manuf. such as PCBway to supply them form the Gerber files.

 

It is illegal to make the signal jammers block extremely important communications from ambulances, fire trucks and cell phones calling for 911. Neighbors will complain that you are causing illegal TV and radio interference.

Maybe the very high voltages will kill you and everybody near you.

 

Thread Locked Pending Moderation.