All About Circuits

Need a hand to Raise!

Search Forums New Posts
Shafty

Thread Starter

Shafty

Joined Apr 25, 2023
327
Hi All,

Good Evening. I am Prabhakaran from India. Gaining knowledge on Asterisk step-by-step. Currently in a level to try things practically. Anyone ready to give a hand to raise a budding Asterisk Programmer…

Kindly contact me if you want give a chance to build an intercom, IVR, voicemail and other telephony solutions.
 
Papabravo

Papabravo

Joined Feb 24, 2006
22,058
As you are aware from asking a similar question two weeks ago there is unlikely to be anybody here with the means to help you. Over at ETO there were some threads from 2007-2010, but nothing on the subject for the last decade and a half. I think you are basically SOL.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
cmartinez Need to solder a 4x4mm QFN by hand General Electronics Chat 28
U Need help with under/overvoltage circuit on device using super caps and hand crank generator Analog & Mixed-Signal Design 20
Rossosaurus Need a hand understanding a section on datasheet example schematic (CYPD3177 USB-C Controller) General Electronics Chat 2
W Need to find a transfer function by hand and plot using Matlab Homework Help 3
rambomhtri I need a third hand soldering station, any recommendations? General Electronics Chat 3
Similar threads
Need to solder a 4x4mm QFN by hand
Need help with under/overvoltage circuit on device using super caps and hand crank generator
Need a hand understanding a section on datasheet example schematic (CYPD3177 USB-C Controller)
Need to find a transfer function by hand and plot using Matlab
I need a third hand soldering station, any recommendations?

You May Also Like

Top