All About Circuits

NCP59748MN1 power supply query.

Search Forums New Posts
Rahul Sharma 1

Thread Starter

Rahul Sharma 1

Joined Jan 18, 2018
3
Hi,
I am new here and planning to use NCP59748MN1 part for my power supply.
My input voltage is 1.2V @ 0.8A current and my output voltage is 1.0V @0.8A.

Is it ok to use this IC. For BIAS voltage I will use 3.5V supply.

Thanks
rah
 

Attachments

Last edited by a moderator:
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
vandveuser16776 Haier HL26P2 TV Power Supply Repair General Electronics Chat 2
thinkboodles How do I power my circuit? and add Voltage sources in mV ? PCB Layout , EDA & Simulations 10
E Working on an RFPD (Radio Frequency Power Detector)D, but I have zero experience designing a circuit board. Analog & Mixed-Signal Design 19
T which components are most vulnerable to ESD?? (switch mode power supply ics?) General Electronics Chat 9
C tracing power to pins on a Marklift board Technical Repair 0
Similar threads
Haier HL26P2 TV Power Supply Repair
How do I power my circuit? and add Voltage sources in mV ?
Working on an RFPD (Radio Frequency Power Detector)D, but I have zero experience designing a circuit board.
which components are most vulnerable to ESD?? (switch mode power supply ics?)
tracing power to pins on a Marklift board

You May Also Like

Top