Hello everyone
I have previously made a motor controller with a TL494 and uses a half bridge L6384. it can handle 40Amp without mosfet get hot. I do not use heatsink.
Now I will try to make a motor controller with a full bridge so that I can run the motor forward and reverse I have found the attached circuit. Do I understand it right, the PWM signal is either set to high or low so that the motor changes direction ?
I I hope someone can help me with this question
best regards
Mejlby
I have previously made a motor controller with a TL494 and uses a half bridge L6384. it can handle 40Amp without mosfet get hot. I do not use heatsink.
Now I will try to make a motor controller with a full bridge so that I can run the motor forward and reverse I have found the attached circuit. Do I understand it right, the PWM signal is either set to high or low so that the motor changes direction ?
I I hope someone can help me with this question
best regards
Mejlby
Attachments
-
4.4 MB Views: 132