I am trying to model this circuit in Orcad Capture CIS but everything I try comes out wrong. I need it to show the voltages for V1,V2, V3, Va and Vb. I already have all the values worked out manually but I need to show this in Orcad.

Thank you.

 

What is the reference point?

 

Hang a ground between battery neg and battery positive in your two batteries in series..

 

Where is your Capture schematic?

 

Hang a ground between battery neg and battery positive in your two batteries in series..

This was the correct way. I tried it earlier but it looks like Orcad was acting up. Once I change the circuit I had to exit and open it again. Only then was I receiving the correct information.

Thanks for the help JoeJester & shteii01.