Mc-60 cuts out video

Thread Starter

sasnecro

Joined Dec 26, 2020
4
I uploaded a video to YouTube I'm hoping that somebody can help me out here. I tried two different motors two different chokes two different 5K potentiometers. I don't care if someone wants to call me through a video chat and walk through this here's the link to the video.

 

Thread Starter

sasnecro

Joined Dec 26, 2020
4
It may sound like it but it is very slow I would have to say around 600 to 1,000 revolution
As long as I put a little bit of pressure on it it doesn't do the bounce anymore but I can't get it to go past quarter throttle if I go from zero and move it any faster than a very very slow speed it'll cut off too. And I mean really turn that thing slow
 

Thread Starter

sasnecro

Joined Dec 26, 2020
4
Well the clicking is gone but I have to turn the potentiometer extremely slow to get it to start spooling and then at that point I have to stop probably when it's around a thousand RPM if I pass that it shuts down then I have to wait for it to stop spinning and start again. If I turn the potentiometer fast it does nothing so it has to be extremely slow turning
 
Top