Hello, I am using a Bonder of this type shown bellow.
As you can see bellow, it perfectly doing a bond but its not cutting the wire after the end point of the loop.
I tried to raise the power parameter but it didnt work.
Where did i go in setting the boding maching? what is responsible for cutting the wire after We make the bond??
Thanks.
As you can see bellow, it perfectly doing a bond but its not cutting the wire after the end point of the loop.
I tried to raise the power parameter but it didnt work.
Where did i go in setting the boding maching? what is responsible for cutting the wire after We make the bond??
Thanks.
